EasyManuals Logo

Foundry Networks FESX User Manual

Foundry Networks FESX
820 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #356 background imageLoading...
Page #356 background image
Foundry Configuration Guide for the FESX, FSX, and FWSX
16 - 6 © Foundry Networks, Inc. December 2005
administrative distance of each path and selects the path with the lowest administrative distance. The
administrative distance is a protocol-independent value from 1 – 255.
When the software receives two or more best paths from the same source and the paths have the same
metric (cost), the software can load share traffic among the paths based on destination host or network
address (based on the configuration and the Layer 3 Switch model).
Here is an example of an entry in the IP route table:
Each IP route table entry contains the destination’s IP address and sub-net mask and the IP address of the next-
hop router interface to the destination. Each entry also indicates the port attached to the destination or the next-
hop to the destination, the route’s IP metric (cost), and the type. The type indicates how the IP route table
received the route.
To display the IP route table, see the following:
“Displaying the IP Route Table” on page 16-68 – Layer 3 Switch only
To configure a static IP route, see the following:
“Configuring Static Routes” on page 16-32 – Layer 3 Switch only
To clear a route from the IP route table, see the following:
“Clearing IP Routes” on page 16-70 – Layer 3 Switch only
To increase the size of the IP route table for learned and static routes, see the section “Displaying and Modifying
System Parameter Default Settings” on page 4-8.
For learned routes, modify the ip-route parameter.
For static routes, modify the ip-static-route parameter.
IP Forwarding Cache
The IP forwarding cache provides a fast-path mechanism for forwarding IP packets. The cache contains entries
for IP destinations. When a Foundry Layer 3 Switch has completed processing and addressing for a packet and is
ready to forward the packet, the device checks the IP forwarding cache for an entry to the packet’s destination.
If the cache contains an entry with the destination IP address, the device uses the information in the entry to
forward the packet out the ports listed in the entry. The destination IP address is the address of the packet’s
final destination. The port numbers are the ports through which the destination can be reached.
If the cache does not contain an entry and the traffic does not qualify for an entry in the session table instead,
the software can create an entry in the forwarding cache.
Each entry in the IP forwarding cache has an age timer. If the entry remains unused for ten minutes, the software
removes the entry. The age timer is not configurable.
Here is an example of an entry in the IP forwarding cache:
Each IP forwarding cache entry contains the IP address of the destination, and the IP address and MAC address
of the next-hop router interface to the destination. If the destination is actually an interface configured on the Layer
3 Switch itself, as shown here, then next-hop information indicates this. The port through which the destination is
reached is also listed, as well as the VLAN and Layer 4 QoS priority associated with the destination if applicable.
To display the IP forwarding cache, see “Displaying the Forwarding Cache” on page 16-66.
Destination NetMask Gateway Port Cost Type
1.1.0.0 255.255.0.0 99.1.1.2 1/1 2 R
IP Address Next Hop MAC Type Port Vlan Pri
1 192.168.1.11 DIRECT 0000.0000.0000 PU n/a 0

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Foundry Networks FESX and is the answer not in the manual?

Foundry Networks FESX Specifications

General IconGeneral
BrandFoundry Networks
ModelFESX
CategorySwitch
LanguageEnglish

Related product manuals