Configuring IP
December 2005 © Foundry Networks, Inc. 16 - 61
To display CPU utilization statistics for the previous one-second, one-minute, five-minute, and fifteen-minute
intervals, enter the following command at any level of the CLI:
If the software has been running less than 15 minutes (the maximum interval for utilization statistics), the
command indicates how long the software has been running. Here is an example:
FESX424 Router# show process cpu
Process Name 5Sec(%) 1Min(%) 5Min(%) 15Min(%) Runtime(ms)
ACL 0.00 0.00 0.00 0.00 0
ARP 0.01 0.01 0.01 0.01 714
BGP 0.00 0.00 0.00 0.00 0
DOT1X 0.00 0.00 0.00 0.00 0
GVRP 0.00 0.00 0.00 0.00 0
ICMP 0.00 0.00 0.00 0.00 161
IP 0.00 0.00 0.00 0.00 229
L2VLAN 0.01 0.00 0.00 0.01 673
OSPF 0.00 0.00 0.00 0.00 0
RIP 0.00 0.00 0.00 0.00 9
STP 0.00 0.00 0.00 0.00 7
VRRP 0.00 0.00 0.00 0.00 0
FESX424 Router# show process cpu
The system has only been up for 6 seconds.
Process Name 5Sec(%) 1Min(%) 5Min(%) 15Min(%) Runtime(ms)
ACL 0.00 0.00 0.00 0.00 0
ARP 0.01 0.01 0.01 0.01 714
BGP 0.00 0.00 0.00 0.00 0
DOT1X 0.00 0.00 0.00 0.00 0
GVRP 0.00 0.00 0.00 0.00 0
ICMP 0.00 0.00 0.00 0.00 161
IP 0.00 0.00 0.00 0.00 229
L2VLAN 0.01 0.00 0.00 0.01 673
OSPF 0.00 0.00 0.00 0.00 0
RIP 0.00 0.00 0.00 0.00 9
STP 0.00 0.00 0.00 0.00 7
VRRP 0.00 0.00 0.00 0.00 0
To Next Page
Loading...
