Foundry Networks Switch and Router User Manual

Securing Access to Management Functions
December 2000 3 - 43
The show web command displays the privilege level of Web management interface users. For example:
ServerIron(config)#show web
User Privilege IP address
set 0 192.168.1.234
Syntax: show web
USING THE WEB MANAGEMENT INTERFACE
To configure RADIUS using the Web management interface:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. If you configuring RADIUS authentication for Telnet access to the CLI, go to step 3. Otherwise, go to step 7.
3. Select the Management
link to display the Management configuration panel.
4. Select Enable next to Telnet Authentication. You must enable Telnet authentication if you want to use
TACACS/TACACS+ or RADIUS to authenticate Telnet access to the device.
5. Click Apply to apply the change.
6. Select the Home
link to return to the System configuration panel.
7. Select the RADIUS link from the System configuration panel to display the RADIUS panel.
8. Change the retransmit interval, time out, and dead time if needed.
9. Enter the authentication key if applicable.
10. Click Apply if you changed any RADIUS parameters.
11. Select the RADIUS Server
link.
• If any RADIUS servers are already configured on the device, the servers are listed in a table. Select the
Add RADIUS Server
link to display the following panel.
• If the device does not have any RADIUS servers configured, the following panel is displayed.
connection The current connection status. This can be “no connection” or “connection active”.
Table 3.6: Output of the show aaa command for RADIUS
Field Description

Foundry Networks Switch and Router Specifications

General

Brand	Foundry Networks
Model	Switch and Router
Category	Switch
Language	English