Foundry Networks Switch and Router - Page 352

Foundry Switch and Router Installation and Configuration Guide
11 - 20 December 2000
Figure 11.2 and Figure 11.3 show the CLI syntax for configuring a Layer 4 QoS policy on a Foundry router. Notice
that the syntax differs slightly depending on whether you are configuring a Stackable router or a Chassis router.
Figure 11.2 QoS IP policy syntax for a Foundry router (1 of 2)
<num>
ip access-policy
high | normal (stackable)
priority <num> (chassis)
<src-ip-addr> <ip-mask>|any
<dst-ip-addr> <ip-mask>|any
icmp
bgp | dns |
ftp | http |
imap4 | ldap |
nntp | pop2 |
pop3 | smtp |
ssl | telnet |
<num>
<num>
tcp
eq
gt
lt
neq
range
established
<CR>
eq
gt
lt
neq
range
<CR>
bgp | dns |
ftp | http |
imap4 | ldap |
nntp | pop2 |
pop3 | smtp |
ssl | telnet |
<num>
bgp | dns |
ftp | http |
imap4 | ldap |
nntp | pop2 |
pop3 | smtp |
ssl | telnet |
<num>
bgp | dns |
ftp | http |
imap4 | ldap |
nntp | pop2 |
pop3 | smtp |
ssl | telnet |
<num>
bgp | dns |
ftp | http |
imap4 | ldap |
nntp | pop2 |
pop3 | smtp |
ssl | telnet |
<num>
bgp | dns |
ftp | http |
imap4 | ldap |
nntp | pop2 |
pop3 | smtp |
ssl | telnet |
<num>
udp
see the next page...
<CR>
<CR>
<CR>
<CR>
<CR>
<CR>
igmp
<CR>
igrp
<CR>
ospf
<CR>