Foundry Switch and Router Installation and Configuration Guide
18 - 32 December 2000
Enabling MSDP
Use the following CLI method to enable MSDP.
USING THE CLI
To enable MSDP, enter the following command at the global CONFIG level of the CLI. This command also places
you at the MSDP configuration level of the CLI.
BigIron(config)# router msdp
BigIron(config-msdp-router)#
Syntax: [no] router msdp
USING THE WEB MANAGEMENT INTERFACE
You cannot configure MSDP using the Web management interface.
Configuring MSDP Peers
Use the following CLI method to configure an MSDP peer.
USING THE CLI
To configure an MSDP peer, enter a command such as the following at the MSDP configuration level.
BigIron(config-msdp-router)# msdp-peer 205.216.162.1
Syntax: [no] msdp-peer <ip-addr>
USING THE WEB MANAGEMENT INTERFACE
You cannot configure MSDP using the Web management interface.
Displaying MSDP Information
You can display the following MSDP information:
• Summary information – the IP addresses of the peers, the state of the Layer 3 Switch’s MSDP session with
each peer, and statistics for Keepalive, Source Active, and Notification messages sent to and received from
each of the peers
• Peer information – the IP address of the peer, along with detailed MSDP and TCP statistics
• Source Active cache entries – the Source Active messages cached by the Layer 3 Switch
Displaying Summary Information
To display summary MSDP information, use the following CLI method.
USING THE CLI
To display summary MSDP information, enter the following command at any level of the CLI:
BigIron(config-msdp-router)# show ip msdp summary
MSDP Peer Status Summary
KA: Keepalive SA:Source-Active NOT: Notification
Peer Address State KA SA NOT
In Out In Out In Out
206.251.17.30 ESTABLISH 3 3 0 640 0 0
206.251.17.41 ESTABLISH 0 3 651 0 0 0
Syntax: show ip msdp summary
This display shows the following information.
To Next Page
Loading...
Need help?
General
