205
EN
"Select the push-pull motor" screen
Select corresponding push-pull motor
using the adjusting dial (18)
Press F2 "Forward":
– The 2nd screen in the wizard ap-
pears ("Disengage the wire")
"Disengage the wire" screen
Follow the instructions given in the "Di-
sengage the wire" screen
Press F2 "Forward":
– The VR alignment is started, the
3rd in the wizard appears ("No-
load alignment")
"Disengage the wire" screen
Once no-load alignment is complete, the
4th screen in the wizard appears "Engage
the wire".
4
5
6
7
To Next Page
Loading...