37
EN
MIG/MAG synergic welding: "Working parameters"
screen, "no program" for "CMT" process
If the set welding program and the selected
process do not correspond, or if there is no
welding program for the selected process,
"no program" appears in the display area.
The "Wirefeed speed" parameter cannot be
altered.
Individual parameters are displayed differently depending on the selected process and
welding program:
"Pulse correction" parameter in the pulse process "Dynamic correction" parameter in the standard pro-
cess
Process Parameter
Pulse Pulse correction
Standard Dynamic correction
in the CMT process HotStart time
Pulse correction
HotStart pulse cycles
Boost correction
Dynamic correction
To Next Page
Loading...