59
EN
"Name characteristic" screen
Select corresponding characters using
the adjusting dial (18)
Press F4 ">" to enter the next charac-
ter
– Corrections can be carried out
using F3 "<" or F2 "< Delete".
Press F1 "Accept" when finished:
– The new name is accepted, "Cre-
ate new characteristic point"
screen appears
"Create new characteristic point" screen
Press F2 "Forward":
– The 2nd screen in the wizard ap-
pears as confirmation ("Create
new characteristic point")
"Create new characteristic point" screen: confirmation
of the saved characteristic point
Press F2 "Done":
– The characteristic point is saved,
the corresponding "Data" screen
appears.
– By pressing F1 "Back", the
screens of the steps already per-
formed can be displayed again.
Changes can be made.
9
10
11
12
13
To Next Page
