Chapter 9 Connectivity Management
9.2 Functions in the Action Area for Connectivity
ETERNUS Web GUI User’s Guide
351
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
The procedure to modify a port group is as follows:
1 Select the port group to be changed, and click [Modify Port Group] in [Action].
2 Specify the name of the new port group, add a port to the port group (select the
checkbox), or delete a port from the port group (clear the checkbox), and click
the [Modify] button.
• Name
Specify the port group name.
An existing port group name cannot be specified.
The following input conditions apply:
- 1 - 16 alphanumeric characters and symbols (except ", (comma)" and "?")
- Space
• Checkbox to select a port
The checkbox of the port, which has been registered in the port group, is selected.
Select the port checkbox to be added to a port group. Clear the port checkbox to be
deleted from a port group.
- When one port is registered in several port groups, and the host
affinity setting has been configured on one of the port groups
including the corresponding port, the same affinity setting is
configured on all the port groups, which include the corresponding
port, and also on the member ports.
- Ports without the host affinity setting can be members of a port
group, regardless of whether the affinity mode for the group is
enabled (On) or disabled (Off).
• When a port was added to a port group, of which the host affinity setting
has been configured, paths between all the hosts with the host affinity
setting and the added port will be configured. To modify the path
between a host and a port, refer to "9.2.1.3 Modify Host Affinity" (page
290).
• When a port in the port group for which the host affinity settings are
already configured is deleted, the path from the host to the port is also
deleted.
• When creating a new port group and registering a port in the port group,
refer to "9.2.3.1 Create FC Port Group" (page 339)
, "9.2.3.2 Create
iSCSI Port Group" (page 341), "9.2.3.3 Create SAS Port Group" (page
344), or "9.2.3.4 Create FCoE Port Group" (page 347) depending on the
CA port type.
• To change the port mode from "RA" to "CA", refer to "9.2.3.11 Modify
Port Mode" (page 373).
To Next Page
Loading...