Fujitsu PRIMERGY BX900 - Page 250

© 2011 Fujitsu Technology Solutions
248
9.3.18.2 Status
Figure : Port Channel Status
Non-Configurable Data
Port Channel - The Slot/Port identification of the Port Channel.
Port Channel Name - The name of the Port Channel.
Port Channel Type - The type of this Port Channel.
Admin Mode - The Administrative Mode of the Port Channel, enable or disable.
Static Capability Mode - The Static Capability Mode of the Port Channel, enable or disable
Link Status - Indicates whether the Link is up or down.
STP Mode - The Spanning Tree Protocol Administrative Mode associated with the Port Channel.
The possible values are:
• Disable - spanning tree is disabled for this Port Channel.
• Enable - spanning tree is enabled for this Port Channel.
Link Trap - Whether or not a trap will be sent when link status changes. The factory default is
enable.
Configured Ports - A list of the ports that are members of the Port Channel, in Slot/Port notation.
There can be a maximum of 8 ports assigned to a Port Channel.
Active Ports - A listing of the ports that are actively participating members of this Port Channel, in
Slot/Port notation. There can be a maximum of 8 ports assigned to a Port Channel.
Load Balance - Display load balance mode information. The possible values are:
• Source MAC address - Sets the mode on the source MAC address.
• Destination MAC address - Sets the mode on the destination MAC address.
• Source and destination MAC address - Sets the mode on the source and destination MAC
addresses.
• Source IP address - Sets the mode on the source IP address.
• Destination IP address - Sets the mode on the destination IP address.
• Source and destination IP address - Sets the mode on the source and destination IP
addresses.