Fujitsu PRIMERGY BX900 - Page 302

© 2011 Fujitsu Technology Solutions
300
9.4.5.2 Server Config
Figure : TACACS+ Server Config
Selection Criteria
TACACS+ Server - Selects the TACACS+ server for which data is to be displayed or configured. If
the add item is selected, a new TACACS server can be configured.
Configurable Data
IPv4 Address - Specifies the TACACS+ Server IPv4 address.
You cannot define these IP addresses:
− 0.0.0.0
− 255.255.255.255
− 224.xxx.xxx.xxx
− 127.0.0.1
IPv6 Address - - The IPv6 address of the server being added.
You cannot define these IPv6 addresses:
− 0::0 (Unspecified)
− 0::1 (Loopback)
− Multicast
Host Name -The host name of the server being added.
Priority - Specifies the order in which the TACACS+ servers are used. It should be within the range
0-65535.
Port - Specifies the authentication port. It should be within the range 0-65535.
Key String - Specifies the authentication and encryption key for TACACS+ communications
between the device and the TACACS+ server. The valid range is 0-128 characters. The key must
match the encryption used on the TACACS+ server.
Encrypted - When the key string is encrypted, this box need to be checked. This field is only
displayed if the user has READWRITE access.
Connection Timeout - The amount of time that passes before the connection between the device
and the TACACS+ server time out. The range is between 1-30.
Command Buttons