Fujitsu PRIMERGY BX900 - Page 413

© 2011 Fujitsu Technology Solutions
411
This command adds all physical interfaces to the protocol-based VLAN identified by <group-name>. A
group may have more than one interface associated with it. Each interface and protocol combination can
only be associated with one group. If adding an interface to a group causes any conflicts with protocols
currently associated with the group, this command will fail, and the interface(s) will not be added to the
group.
Syntax
switchport protocol group all <group-name>
no switchport protocol group all <group-name>
<group-name> - a VLAN Group Name (a character string of 1 to 16 characters).
all - All interfaces.
no - This command removes all interfaces from this protocol-based VLAN group that is identified by
this <group-name>.
Default Setting
None
Command Mode
Global Config
This command adds the <protocol> to the protocol-based VLAN identified by <group-name>. A group
may have more than one protocol associated with it. Each interface and protocol combination can only
be associated with one group. If adding a protocol to a group causes any conflicts with interfaces
currently associated with the group, this command will fail, and the protocol will not be added to the
group. The possible values for protocol are ip, arp, and ipx.
Syntax
switchport protocol group add protocol <group-name> {ip | arp | ipx}
no switchport protocol group add protocol <group-name> {ip | arp | ipx}
<group-name> - a VLAN Group Name (a character string of 1 to 16 characters).
ip - IP protocol.
arp - ARP protocol.
ipx - IPX protocol.
no - This command removes the <protocol> from this protocol-based VLAN group that is identified
by this <group-name>. The possible values for protocol are ip, arp, and ipx.
Default Setting
None
Command Mode
Global Config