© 2011 Fujitsu Technology Solutions
423
This command sets the GVRP leave time for all ports. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service. The time is from 20 to 600 (centiseconds).
Syntax
garp timer leave all < 20-600 >
no garp timer leave all
<20-600> - leave time (Range: 20 – 600) in centiseconds.
all - All interfaces.
no - This command sets the GVRP leave time for all ports to the default 60 centiseconds (0.6
seconds).
i
This command has an effect only when GVRP or GMRP is enabled.
Default Setting
60 centiseconds (0.6 seconds)
Command Mode
Global Config
To Next Page
Loading...
