Fujitsu PRIMERGY BX900 - Page 466

© 2011 Fujitsu Technology Solutions
464
10.4.9.1.2 Display MLD snooping querier vlan information
This command display MLD snooping querier vlan information on the system.
Syntax
show ipv6 mld snooping querier vlan <1-4093>
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
MLD Snooping Querier Vlan Mode: Displays the querier election participate mode on the VLAN.
When this mode is disabled, up on seeing a query of the same version in the vlan, the snooping
querier move to non querier state. Only when this mode is enabled, the snooping querier will
participate in querier election where in the least ip address will win the querier election and operates
as the querier in that VLAN. The other querier moves to non-querier state.
Querier Vlan Address: Displays the Snooping Querier Address to be used as source address in
periodic MLD queries sent on the specified VLAN.
Operational State: Specifies the operational state of the MLD Snooping Querier on a VLAN.
Operational Version: Displays the operational MLD protocol version of the querier.
10.4.9.1.3 Display MLD snooping querier all of information
This command display all of MLD snooping querier information on the system.
Syntax
show ipv6 mld snooping querier detail
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
MLD Snooping Querier Mode: Administrative mode for MLD Snooping. The default is disable
Querier Address: Specify the Snooping Querier Address to be used as source address in periodic
MLD queries. This address is used when no address is configured on the VLAN on which query is
being sent.
MLD Version: Specify the MLD protocol version used in periodic IGMP queries.