Fujitsu PRIMERGY BX900 - Page 493

© 2011 Fujitsu Technology Solutions
491
10.4.13.2 queue cos-map
This command is used to assign class of service (CoS) value to the CoS priority queue.
Syntax
queue cos-map <priority> <queue-id>
no queue cos-map
<queue-id> - The queue id of the CoS priority queue (Range: 0 - 7 ).
<priority> - The CoS value that is mapped to the queue id (Range: 0 - 7 ).
no - Sets the CoS map to the default values.
Default Setting
priority queue
0 1
1 0
2 0
3 1
4 2
5 2
6 3
7 3
Command Mode
Interface Config