© 2011 Fujitsu Technology Solutions
519
10.6.3.12 telnet exec-timeout
This command sets the outbound telnet session timeout value in minute.
Syntax
telnet exec-timeout <1-160>
no telnet exec-timeout
<1-160> - max connect time (Range: 1 -160).
no - This command sets the remote connection session timeout value, in minutes, to the default.
i
Changing the timeout value for active sessions does not become effective until the session
is reaccessed. Any keystroke will also activate the new timeout duration.
Default Setting
5
Command Mode
Global Config
10.6.3.13 show telnet
This command displays the current outbound telnet settings.
Syntax
show telnet
Default Setting
None
Command Mode
User Exec, Privileged Exec
Display Message
Outbound Telnet Login Timeout (in minutes): Indicates the number of minutes an outbound telnet
session is allowed to remain inactive before being logged off. A value of 0, which is the default,
results in no timeout.
Maximum Number of Outbound Telnet Sessions: Indicates the number of simultaneous
outbound telnet connections allowed.
Allow New Outbound Telnet Sessions: Indicates whether outbound telnet sessions will be
allowed.
To Next Page
Loading...
