Fujitsu PRIMERGY BX900 - Page 539

© 2011 Fujitsu Technology Solutions
537
10.6.6.2 snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See 'snmp-server
enable traps linkmode' command.
Syntax
snmp trap link-status
no snmp trap link-status
no - This command disables link status traps by interface.
Default Setting
Disabled
Command Mode
Interface Config
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (See 'snmp-server enable
traps linkmode' command.)
Syntax
snmp trap link-status all
no snmp trap link-status all
all - All interfaces.
no - This command disables link status traps for all interfaces.
Default Setting
Disabled
Command Mode
Global Config