Fujitsu PRIMERGY BX900 - Page 541

© 2011 Fujitsu Technology Solutions
539
10.6.6.5 snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive
traps). Disabled trap receivers are inactive (not able to receive traps).
Syntax
snmptrap mode <name> <ipaddr | ipv6Addr>
no snmptrap mode <name> <ipaddr | ipv6Addr>
<name> - SNMP trap name.
<ipadd | ipv6Addr> - an IPv4 or IPv6 address.
no - This command deactivates an SNMP trap. Trap receivers are inactive (not able to receive
traps).
Default Setting
None
Command Mode
Global Config
10.6.6.6 snmptrap snmpversion
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive
traps). Disabled trap receivers are inactive (not able to receive traps).
Syntax
snmptrap snmpversion <name> <ipaddr | ipv6Addr> <snmpv1|snmpv2| snmpv3>
<name> - SNMP trap name.
<ipadd | ipv6Addr> - an IPv4 or IPv6 address.
snmpv1 - Use SNMP v1 to send traps.
snmpv2 - Use SNMP v2 to send traps.
Snmpv3 - Use SNMP v3 to send traps.
Default Setting
None
Command Mode
Global Config