Fujitsu PRIMERGY BX900 - Page 685

© 2011 Fujitsu Technology Solutions
683
This command is to Enable/Disable a link state group. Use ‘link state group enable <group id> to enable
individual group, and use no command to disable a group.
Syntax
link state group enable <group id>
no link state group enable <group id>
<group id> - link state group id (Range: 1~32).
no - This command disable link state group.
Default Setting
Disable
Command Mode
Global Config
This command is to Set upstream port or downstream port for a link state group. Use ‘link state group
<group id> upstream’ to set the port to be monitored.
Syntax
link state group <group id> upstream
link state group < group id> downstream
<group id> - link state group id (Range: 1~32).
Upstream/ Downstream port(s) - The list of interfaces that are designated for Up/Down Stream port
number.
Default Setting
Disable
Command Mode
Interface Config