Fujitsu PRIMERGY BX900 - Page 689

© 2011 Fujitsu Technology Solutions
687
This command is to Set active port or backup port for a port-backup group. Use ‘port-backup group <group
id> <active | backup>’ to set the port to be configured active or configured backup port.
Syntax
port-backup group <group id> {active | backup}
no port-backup group <group id> {active | backup}
<group id> - port backup group id (Range: 1~32).
no - This command remove active/backup port from a port backup group.
Default Setting
None
Command Mode
Interface Config