Fujitsu PRIMERGY BX900 - Page 783

© 2011 Fujitsu Technology Solutions
781
10.18.2.8 ip access-list
Use this command to create an extended IP Access Control List (ACL) identified by <name>, consisting of
classification fields defined for the IP header of an IPv4 frame. The <name> parameter is a case-sensitive
alphanumeric string from 1 to 31 characters uniquely identifying the IP access list.
If an IP ACL by this name already exists, this command enters IPv4-Access_List config mode to allow
updating the existing IP ACL.
The CLI mode changes to IPv4-Access-List Configuration mode when you successfully execute this
command.
Syntax
Ip access-list <name>
no ip access-list <name>
no - This command removes the IP ACL identified by <name> from the system.
Default Setting
None
Command Mode
Global Config
10.18.2.9 ip access-list rename
Use this command to change the name of an IP Access Control List (ACL). The <name> parameter is the
names of an existing IP ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1 to
31 characters uniquely identifying the IP access list.
Syntax
ip access-list rename <name> <newname>
Default Setting
None
Command Mode
Global Config