© 2011 Fujitsu Technology Solutions
81
9.2.2.2 In-Band Mgmt
The In-Band Mgmt is the logical interface used for in-band connectivity with the switch via any of the
switch's front panel ports. The configuration parameters associated with the switch's In-Band Mgmt do
not affect the configuration of the front panel ports through which traffic is switched or routed.
To access the switch over a network you must first configure it with IP information (IP address, subnet
mask, and default gateway). You can configure the IP information using any of the following:
• BOOTP
• DHCP
• Terminal interface via the EIA-232 port (with console redirection from MMB)
Once you have established in-band connectivity, you can change the IP information using any of the
following:
• Terminal interface via the EIA-232 port
• Terminal interface via telnet
• SNMP-based management
• Web-based management
Figure : In-Band Mgmt Config
Selection Criteria
IPv6 Mode - Enable/Disable IPv6 stack for in-band mgmt interface.
In-Band Mgmt Protocol - Specify what the switch should do following power-up: transmit a Bootp
request, transmit a DHCP request, or do nothing (None). The factory default is None. You cannot
make this choice for both the In-Band Mgmt Protocol and the Out-of-Band Mgmt . You will only be
given the choices for “None” here if the OOB Interface Configured Protocol is configured to “Bootp”
or “DHCP”.
DHCP6 Client - Selects if the DHCP6 Client is enabled or disabled. You cannot make this choice for
both the In-Band Mgmt and the Out-of-Band Mgmt. You will only be given the choices for Enable
here if the Out-of-Band Mgmt is configured to Disable.
To Next Page
Loading...
