Fujitsu PRIMERGY BX900 - Page 95

© 2011 Fujitsu Technology Solutions
93
9.2.3.3 Set Config to Defaults
Figure : Set Config to Defaults
Command Buttons
Reset - Select this button to have all configuration parameters reset to their factory default values.
All changes you have made will be lost, even if you have issued a save. You will be shown a
confirmation screen after you select the button.
9.2.3.4 Set Passwords to Defaults
Figure : Set Passwords to Defaults
Command Buttons
Reset - Clicking the Reset button will reset all of the system login passwords to their default values.
If you want the switch to retain the new values across a power cycle, you must perform a save.