▶
Remove the two screws (see circles).
▶
Remove the front VGA cable from the server inside through the opening.
Installing the new front VGA
▶
Install the front VGA, see "Installing the front VGA" on page 272.
Concluding steps
▶
"Installing the air duct" on page
66
.
▶
"Reassembling" on page 53.
▶
"Connecting the power cord" on page 57.
▶
"Switching on the server" on page 60.
▶
If applicable, "Installing the front cover with lock" on page 61.
13.5 Front USB
13.5.1 Replacing the front USB in the front VGA module
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: – Phillips PH2 / (+) No. 2 screw driver
– Phillips PH1 / (+) No. 1 screw driver
Preliminary steps
▶
If applicable, "Removing the front cover with lock" on page 45
.
▶
"Shutting down the server" on page 46.
▶
"Disconnecting the power cord" on page 47.
▶
"Getting access to the component" on page 49.
▶
"Removing the air duct" on page 65.
Front panel
RX1330 M5 Upgrade and Maintenance Manual 275
To Next Page
Loading...
