Fujitsu PRIMERGY RX1330 M5 User Manual

Concluding steps
▶
Install all riser modules, see "Installing a riser module" on page 64.
▶
Install all fan modules, see "Installing the new fan module" on page
176.
▶
Install the air duct, see "Installing the air duct" on page 66.
▶
Install the system board, see "Installing the new system board" on page 333.
▶
"Reassembling" on page 53.
▶
Install all PSUs, see "Installing a hot-plug PSU" on page 102.
▶
"Connecting the power cord" on page 57.
▶
"Switching on the server" on page 60.
▶
If applicable, "Installing the front cover with lock" on page 61.
▶
"Resuming BitLocker functionality" on page 86.
You can find information on configuring the TPM in the corresponding
BIOS Setup Utility reference manual.
15.5 iRMC microSD card
15.5.1
Note for embedded Lifecycle Management (eLCM)
The iRMC microSD card is necessary for using the embedded Lifecycle
Management (eLCM) functionality of the iRMC. It requires a valid eLCM
license key from user purchase order and activated through the iRMC
web interface.
For more information, see the “ServerView embedded Lifecycle
Management (eLCM)” user guide.
System board and components
RX1330 M5 Upgrade and Maintenance Manual 305

Fujitsu PRIMERGY RX1330 M5 Specifications

General

Processor Sockets	1
Memory	Up to 128 GB
Memory Type	DDR4
Form Factor	1U rack server
Memory Slots	4 DIMM slots
Storage	Up to 4x 3.5" or 8x 2.5" drives
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Network	2x 1GbE LAN ports
Power Supply	800W