Fujitsu PRIMERGY RX1330 M5 User Manual

Concluding steps
▶
Install the corresponding riser module, see "Installing a riser module" on
page 64
.
▶
"Reassembling" on page 53.
▶
If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page 57.
▶
"Switching on the server" on page 60.
▶
If applicable, "Installing the front cover with lock" on page 61.
▶
"Enabling replaced components in the BIOS" on page 81.
▶
Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 88.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 85.
▶
"Updating expansion card firmware" on page 77.
▶
"Resuming BitLocker functionality" on page 86.
▶
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card).
Configuration of network settings should be performed by the
customer. For more information, see
"Note on network settings
recovery".
▶
If applicable, restore LAN teaming configurations, see "After replacing or
upgrading LAN controllers" on page 93.
9.5.5
Replacing a riser card
Field Replaceable Unit
(FRU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Expansion cards and backup units
204 Upgrade and Maintenance Manual RX1330 M5

Fujitsu PRIMERGY RX1330 M5 Specifications

General

Processor Sockets	1
Memory	Up to 128 GB
Memory Type	DDR4
Form Factor	1U rack server
Memory Slots	4 DIMM slots
Storage	Up to 4x 3.5" or 8x 2.5" drives
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Network	2x 1GbE LAN ports
Power Supply	800W