4.6.3 Installing the server in the rack
CAUTION
At least two people are needed to position the server on the rack rails.
(For Japan, see "安全上のご注意".)
For configurations below 32 kg:
At least two people are needed to lift the server into the
rack cabinet.
For configurations below 55 kg:
At least three people are needed to lift the server into
the rack cabinet.
For configurations above 55 kg:
At least four people are needed to lift the server into the
rack cabinet.
Additionally, a lifter is required in the following cases:
–
The server weighs more than 50 kg.
–
The server weighs more than 21 kg and is to be installed above the height of
25 U.
When using a lifter, this installation procedure needs to be carried out by
maintenance personnel.
Basic hardware procedures
RX1330 M5 Upgrade and Maintenance Manual 55
To Next Page
Loading...
