Fujitsu PRIMERGY RX1330 M5 User Manual

After replacing or upgrading LAN controllers
You need to restore the configuration for the LAN T
eaming, using the LAN
driver utility or OS teaming software.
▶
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
For more information, see the relevant LAN driver manual.
After replacing a system board
The following procedure must be done for each system board that is
replaced.
▶
Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
▶
If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility or OS teaming software.
For more information, see the relevant LAN driver manual.
5.3.16 Switching off the ID indicator
▶
Press the ID button on the front panel, or use the iRMC S6 web interface or
the Infrastructure Manager to switch off the ID indicator after the
maintenance task has been concluded successfully
.
For more information, see "Locating the defective server" on page 43
or
the "ServerView Suite Local Service Concept (LSC)", the iRMC user
guides or the Infrastructure Manager documentation.
Using the ID button on the front panel
▶
Press the ID button on the front panel to switch off the ID indicators.
Basic software procedures
RX1330 M5 Upgrade and Maintenance Manual 93

Fujitsu PRIMERGY RX1330 M5 Specifications

General

Processor Sockets	1
Memory	Up to 128 GB
Memory Type	DDR4
Form Factor	1U rack server
Memory Slots	4 DIMM slots
Storage	Up to 4x 3.5" or 8x 2.5" drives
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Network	2x 1GbE LAN ports
Power Supply	800W