CAUTION
â–¶
Only use CDs/DVDs/BDs that are in perfect condition, in order to prevent
data loss, equipment damage and injury.
â–¶
Check each CD/DVD/BD for damage, cracks, breakages etc. before
inserting it in the drive.
Note that any additional labels applied may change the mechanical
properties of a CD/DVD/BD and cause imbalance and vibrations.
Damaged and imbalanced CDs/DVDs/BDs can break at high drive speeds
(data loss).
Under certain circumstances, sharp CD/DVD/BD fragments can pierce the
cover of the ODD (equipment damage) and can fly out of the drive (danger
of injury
, particularly to uncovered body parts such as the face or neck).
â–¶
High humidity and airborne dust levels are to be avoided. Electric shocks
and/or server failures may be caused by liquids such as water, or metallic
items, such as paper clips, entering a drive.
â–¶
Shocks and vibrations are also to be avoided.
â–¶
Do not insert any objects other than the specified CDs/DVDs/BDs.
â–¶
Do not pull on, press hard, or otherwise handle the CD/DVD/BD tray
roughly.
â–¶
Do not disassemble the ODD.
â–¶
Before use, clean the ODD tray using a soft, dry cloth.
â–¶
As a precaution, remove disks from the ODD when the drive is not to be
used for a long time. Keep the ODD tray closed to prevent foreign matter,
such as dust, from entering the ODD.
â–¶
Hold CDs/DVDs/BDs by their edges to avoid contact with the disk surface.
â–¶
Do not contaminate the CD/DVD/BD surface with fingerprints, oil, dust, etc.
If dirty, clean with a soft, dry cloth, wiping from the center to the edge. Do
not use benzene, thinners, water, record sprays, antistatic agents, or
silicone-impregnated cloth.
â–¶
Be careful not to damage the CD/DVD/BD surface.
â–¶
Keep the CDs/DVDs/BDs away from heat sources.
Important information
34 Upgrade and Maintenance Manual RX1330 M5
To Next Page
Loading...
Need help?
General
