Gamatronic Power+ - Figure 144: Module Config. Setup Menu; Figure 145: Setting the Module;S Voltage; Figure 146: Module Config. Setup Menu; Figure 147: Updating the Module;S Voltage;Frequency;Phase

GAMATRONIC ELECTRONIC INDUSTRIES LTD.
POWER
+
PARALLEL
UPS,
USER GUIDE
,
REL
.
2.0
87
7.9.3 Setting Module/s Voltage
1. Select Module/s voltage:
[Main Menu > SETUP > (password) > Module conf.]
1. Num of phase 5.Output Adjust
2. Module/s frequency 6.Frequency Limits
3. Module/s voltage 7.DC Calibration
4. Update Vo/Fr/ph 8.AC Calibration
Figure 144: Module Config. setup menu
2. Use the ▲▼arrow keys to set the module/s voltage, press Ent, and then Esc:
[Main Menu > SETUP > (password) > Module conf. > Module/s voltage]
Module/s voltage 4: 235V
1: 220V 5: 240V
2: 225V 6: 250V
3: 230V (selected) 5: 260V
Figure 145: Setting the Module/s voltage
7.9.4 Update Voltage/Frequency/Phase
1. Select Update Vo/Fr/ph:
[Main Menu > SETUP > (password) > Module conf.]
1. Num of phase 5.Output Adjust
2. Module/s frequency 6.Frequency Limits
3. Module/s voltage 7.DC Calibration
4. Update Vo/Fr/ph 8.AC Calibration
Figure 146: Module Config. setup menu
2. Press Ent to update, and then Esc:
[Main Menu > SETUP > (password) > Module conf. > Update Vo/Fr/ph]
Nominal Voltage & Frequency
have been sent to all modules.
Please verify all modules were updated!
Exit this mode by pressing Esc.
Figure 147: Updating the Module/s voltage/frequency/phase