151
Figure 307: Connections betweent the Power+ controller and the Wing
5. Connect the supplied power cable between the 12 Vdc socket on the left side of the controller rear
panel and the Wing.
6. On a computer that is connected to the same network as the Power+, open a web browser, type
the IP address of the Power+ into the URL bar, and press Enter.
The home page of the Power+ web interface is displayed.
(If you do not know the Power+'s IP address, you can see it by pressing and holding the Esc
button for 2 or 3 seconds and then choosing "Network" on the displayed menu.)
Verify that an antenna symbol resembling a trident appears in the lower left corner of the browser
window. This indicates that the Wing has a cellular
connection.
Figure 308: Home screen of the Power+ web interface
7. From the Wing home page, navigate to Configuration > SMS notifications.
8. Enter the telephone numbers to which you want to have alarm notifications sent.
To Next Page
Loading...
