Gamatronic Power+ - Setting up the Static Switch; Figure 226: Service > Configure Menu; Figure 227: Static Switch Setup Menu; Figure 228: Set the Mask

GAMATRONIC ELECTRONIC INDUSTRIES LTD.
POWER
+
PARALLEL
UPS,
USER GUIDE
,
REL
.
2.0
113
7.12.3.4 Setting up the Static Switch
1. Select Static Switch Setup:
[Main Menu > SETUP > (password) > Ent > Service > Configure]
1> # OF UPSs (redundancy) 5> Dry, Alarms
2> # OF UPSs (total) 6> Calibration
3> # OF BATT 7> Parallel/StandAlone
4> Static Switch Setup 8> REM COMMAND
Figure 226: Service > Configure menu
2. Select Set mask:
[Main Menu > SETUP > (password) > Ent > Service > Configure > Static Switch Setup]
1. Set mask
2. Configure BYPASS
Figure 227: Static Switch setup menu
3. Use arrow keys to set the mask, and then press Ent:
[Main Menu > SETUP > (password) > Ent > Service > Configure > Static Switch Setup > Set
mask]
Set mask
01
Figure 228: Set the mask
4. Select Configure BYPASS:
[Main Menu > SETUP > (password) > Ent > Service > Configure > Static Switch Setup]
1. Set mask
2. Configure BYPASS
Figure 229: Static Switch setup menu