Gamatronic Power+ - Replacing the Parallel Controller; Figure 287: Setting Parallel Operation

GAMATRONIC ELECTRONIC INDUSTRIES LTD.
POWER
+
PARALLEL
UPS,
USER GUIDE
,
REL
.
2.0
131
7.16 Replacing the parallel controller
In the event that you are operating two Power+ systems in parallel and, due to controller malfunction or for
some other reason it becomes necessary to replace the controller, the replacement controller must be
instructed to act as a parallel controller.
To do this, select Parallel as shown in Figure 287 below and described in section 7.12.3.7, Selecting
Standalone or Parallel Operation, page 116.
[Main Menu > SETUP > (password) > Ent > Service > Configure > Parallel/StandAlone]
--- Parallel / Stand-Alone Setup ---
SELECT - 1: Stand Alone
SELECT - 2: Parallel (selected)
Figure 287: Setting parallel operation
The new controller is now ready to operate in parallel mode.