8.3 The Main Menu and its options
The Main Menu of Power+’s built-in remote management software consists of a column of option buttons on
the left side of the Main Screen (see Figure 289 on page 133).
Table 12 lists the options in the Main Menu column on the Main Screen, and describes each option briefly.
Each option is described in greater detail in the subsequent sections.
Table 12: Main Menu options
MENU OPTION DESCRIPTION
Main
Displays a condensed system status: Alarm status and basic readings.
Analysis
Shows real-time readings for each input and output phase: voltage, current, kVA, kW,
and power factor.
Modules
Displays status of individual UPS modules, shows input and output ac voltages and
currents, dc voltage, and active alarms if any.
STSW
Displays status of Static Switch, including inverter output voltages and frequency,
bypass voltages and frequency, and active alarms if any.
Log
Displays system log; data can be printed or exported to an Excel file.
Control
From this screen, the following system commands can be executed: Move load to
bypass, move load to inverter, start battery test, abort battery test, LEDs test,
shutdown, startup, restart, simulate load on battery condition, simulate battery status
is low.
Use of this option is disabled by factory default. To enable (or disable), from the
Power+ console main menu choose the following:
(7) Setup > (8) Service > (5) Config > (8) Rem Command
SMS
View received or sent SMS Messages in this screen from this screen (Wing module
must be present). Click Available SMS commands to send an SMS message.
Configuration
Configure the settings of the remote management software.
The Main Menu options are described in more detail below.
To Next Page
Loading...
