UCM6200 Series User Manual
detected. Users can select automatic upgrading by day, by week or by minute.
• By week
Once selected, specify the day of the week to check HTTP/TFTP server
for firmware upgrades or configuration files changes.
• By day
Once selected, specify the hour of the day to check the HTTP/TFTP server
for firmware upgrades or configuration files changes.
• By minute
Once selected, specify the interval X that the SIP end device will request
for new firmware every X minutes.
Specify how firmware upgrading and provisioning request to be sent.
Configure the administrator password for admin level login.
Configure the end-user password for the end user level login.
Select HTTP or HTTPS as the web access protocol.
Configure the port for web access. The valid range is 1 to 65535.
Enable Telnet/SSH access for the SIP end device. If the SIP end device
supports Telnet access, this option controls the Telnet access of the device; if
the SIP end device supports SSH access, this option controls the SSH access
of the device.
Configure the URL/IP address for the syslog server.
Select the level of logging for syslog.
Configure whether the SIP log will be included in the syslog message.
Table 30: Global Policy Parameters->Network Settings
Configure how the SIP end device shall obtain the IP address. DHCP or PPPoE
can be selected.
• DHCP
Once selected, users can specify the Host Name (option 12) of the SIP end
device as DHCP client, and Vendor Class ID (option 60) used by the client
and server to exchange vendor class ID information.
• PPPoE
Once selected, users need specify the Account ID, Password and Service
Name for PPPoE.
Define the Layer 3 QoS parameter. This value is used for IP Precedence, Diff-
To Next Page
Loading...
