UCM6200 Series User Manual
CALL FEATURES
The UCM6200 supports call recording, transfer, call forward, call park and other call features via feature code.
This section lists all the feature codes in the UCM6200 and describes how to use the call features.
Feature Codes
Table 81: UCM6200 Feature Codes
• Default code: #1.
• Enter the code during active call. After hearing "Transfer", you will hear
dial tone. Enter the number to transfer to. Then the user will be
disconnected and transfer is completed.
• Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
• Default code: *2.
• Enter the code during active call. After hearing "Transfer", you will hear
the dial tone. Enter the number to transfer to and the user will be
connected to this number. Hang up the call to complete the attended
transfer.
• Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
Seamless Transfer allows user to perform blind transfer using UCM feature
code without having music on hold presented during the transfer process, it
minimizes the interruption during transfer, making the process smooth and
simple.
During an active call use the feature code (*44 which is the default) followed
by the number you want to transfer to in order to perform the active seamless
transfer.
To Next Page
Loading...
Need help?
General
