VALUE-ADDED FEATURES
FAX Sending
The UCM6200 supports sending Fax via web UI access. This feature can be found on web UI->PBX->Value-
added Features->Fax Sending page. In order to send fax, pre-setup for analog trunk and outbound route is
required. Please refer to [Analog Trunks], [VOIP Trunks] and [Outbound Routes] sections for configuring analog
trunk and outbound route.
After making sure analog trunk or VoIP Trunk is setup properly and UCM6200 can reach out to PSTN numbers
via the trunk, on Fax Sending page, enter the fax number and upload the file to be faxed. Then click on “Send”
to start. The progress of sending fax will be displayed in web UI. Users can also view the sending history is in
the same web page.
Figure 184: Fax Sending in Web UI
Announcements Center
The UCM6200 supports Announcements Center feature which allows users to pre-record and store voice
message into UCM6200 with a specified code. The users can also create group with specified extensions. When
the code and the group number are dialed together in the combination of code + group number, the specified
voice message is sent to all group members and only extensions in the group will hear the voice message.
To Next Page
Loading...
