• Click on “Toggle Selected Template(s)” to toggle the status between enabled/disabled for the selected
templates.
Model configuration
Model templates
Model layer configuration allows users to apply model-specific configurations to different devices. Users could
create/edit/delete a model template by accessing web GUI, page PBX->Zero Config->Model Templates. If
multiple model templates are created and enabled, when the user configures the device in Edit Device dialog-
>Advanced Settings, the user can select to use one of the model template for the device. Please refer to section
[Manage Devices] for more details on using the model template.
For each created model template, users can assign it as default model template. If assigned as default model
template, the values in this model template will be applied to all the devices of this model. There is always only
one default model template that can be assigned at one time on the UCM6200.
The selected model template and the default model template will both take effect when generating the config file
for the device. However, the model template has higher priority to default model template when it comes to the
same setting option/field. If the same option/field has different value configured in the default model template
and the selected model template, the value for this option/field in the selected model template will override the
value in default model template.
• Click on “Create New Template” to add a model template.
Table 33: Create New Model Template
Select to assign this model template as the default model template. The value
of the option in default model template will be overridden if other selected
model template has a different value for the same option.
• Click on to edit the model template.
The editing window for model template is shown in the following figure. In the “Options” field, enter the option
name key word, the option that contains the key word will be listed. User could then select the option and
click on “Add Option” to add it into the model template.
To Next Page
Loading...
Need help?
General
