Reset and Reboot
Users could perform reset and reboot under Web GUI->Maintenance->Reset and Reboot.
To factory reset the device, select the mode type first. There are two different types for reset.
• User Data
All the data including voicemail, recordings, IVR Prompt, Music on Hold, CDR and backup files will be
cleared.
• All
All the configurations and data will be reset to factory default.
Figure 241: Reset and Reboot
Syslog
On the UCM6200, users could dump the syslog information to a remote server under Web GUI->Maintenance-
>Syslog. Enter the syslog server hostname or IP address and select the module/level for the syslog information.
The default syslog level for all modules is "error", which is recommended in your UCM6200 settings because it
can be helpful to locate the issues when errors happen.
Some typical modules for UCM6200 functions are as follows and users can turn on "notic" and "verb" levels
besides "error" level.
pbx: This module is related to general PBX functions.
chan_sip: This module is related to SIP calls.
chan_dahdi: This module is related to analog calls (FXO/FXS).
app_meetme: This module is related to conference bridge.
To Next Page
Loading...
Need help?
General
