UCM6200 Series User Manual
services for a specific device at one time.
The minimum value is 1.
Table 56: Create New IAX Trunk
Select the VoIP trunk type.
• Peer IAX Trunk
• Register IAX Trunk
Configure a unique label to identify this trunk when listed in outbound rules,
inbound rules and etc.
Configure the IP address or URL for the VoIP provider’s server of the trunk.
If enabled, the trunk CID will not be overridden by extension's CID when the
extension has CID configured. The default setting is "No".
Enter the username to register to the trunk from the provider when "Register IAX
Trunk" type is selected.
Enter the password to register to the trunk from the provider when "Register IAX
Trunk" type is selected.
If selected, the trunk will be disabled.
Table 57: IAX Register Trunk Configuration Parameters
Configure a unique label to identify this trunk when listed in outbound rules,
inbound rules and etc.
Configure the IP address or URL for the VoIP provider’s server of the trunk.
If enabled, the trunk CID will not be overridden by extension's CID when the
extension has CID configured. The default setting is "No".
If selected, the trunk will be disabled.
Configure the Caller ID. This is the number that the trunk will try to use when
making outbound calls. For some providers, it might not be possible to set the
CallerID with this option and this option will be ignored. When making outgoing
calls, following rules are used to determine which CallerID will be used if they exist:
• The CallerID configured for the extension will be looked up first.
• If no CallerID configured for the extension, the CallerID configured for the trunk
will be used.
• If the above two are missing, the "Global Outbound CID" defined in Web GUI-
>PBX->Internal Options->General will be used.
Configure the name of the caller to be displayed when the extension has no
CallerID Name configured.
Enter the username to register to the trunk from the provider.
To Next Page
Loading...
