Grandstream Networks UCM6206 - Figure 172: Enable;Disable Feature Codes

P a g e | 262
UCM6200 Series User Manual
Direct Dial Mobile
Phone Prefix
If you have the permission to call mobile phone number, use this prefix plus
the extension number can dial the mobile phone number of this extension
directly.
Call Completion
Request
• Default Code: *11
• This code is for the user who wants to use Call Completion to complete
a call.
Call Completion Cancel
• Default Code: *12
• This code is for the user who wants to cancel Call Completion request.
Enable Spy
Check this box to enable spy feature codes.
Listen Spy
This is the feature code to listen in on a call to monitor performance. Monitor’s
line will be muted, and neither party will hear from the monitor’s extension.
The default setting is *54.
Whisper Spy
This is the feature code to speak to one side of the call (for example, whisper
to employees to help them handle a call). Only one side will be able to hear
from the monitor’s extension. The default setting is *55.
Barge Spy
This is the feature code to join in on the call to assist both parties. The default
setting is *56.
Enable Inbound Multiple
Mode
If enabled, user can switch between different inbound route modes with
feature code. By default, this option is disabled.
Inbound Default Mode
This feature code is used to switch inbound route mode to default mode. The
default setting is *61.
Inbound Mode 1
This feature code is used to switch inbound route mode to mode 1. The
default setting is *62.
The UCM6200 also allows user to one click enable / disable specific feature code. As shown below:
Figure 172: Enable/Disable Feature codes