GRAPHTEC CE6000 SERIES - Page 165

6-5
Supplement
Repeat steps 12 and 13 if following message
prompting to move to the adjustment mark is
displayed.
Number to repeat steps 12 and 13 differs
depending on the specied number of the
adjustment marks. Follow the message that
is displayed.
It will return to ARMS SETTING screen
without scanning when the [4] key (CANCEL)
is pressed.
13 Conrm the position of the tool, and if it is OK, press the
[ENTER] key (SET).
Once all the adjustment marks are specified, DISTANCE entry screen is
displayed.
Supplement
Measured distance is displayed in the top
line in the DISTANCE input screen. Input
value (initially same as measured value) is
displayed under that.
If the input value is not changed, it will
assume that there is no difference between
measured distance and the distance in the
data.
Digits of settings can be changed by pressing
the [FAST] key.
14 Press the POSITION ( ) key to set the original distance on
the data.
Supplement
It will return to default screen without
changing the settings when you press the
POSITION ( ) key (PREVIOUS).
DISTANCE input screen for point 3 is
displayed if it is set to 3POINTS or more, so
repeat steps 13 to 15 to set.
15 Conrm the setting and press the [ENTER] key (SET).
The adjustments based on the registration mark reading will be
completed, and it will return to the default screen.
Reference
Please refer to the following for adjustments when matching the manual position.
2 point matching, ["Point 1" settings] ["Point 2" settings] ["Origin point of the axis adjustment" settings] [Finish]
3 point matching, ["Point 1" settings] ["Point 2" settings] ["Point 3" settings] ["Distance between Point 1-2" settings]
["Distance between Point 1-3" settings] ["Origin point of the axis adjustment" settings] [Finish]
4 point matching, ["Point 1" settings] ["Point 2" settings] ["Point 3" settings] ["Point 4" settings] ["Distance between point
1-2" settings] ["Distance between point 1-3" settings] [Finish]