GRAPHTEC CE6000 SERIES - Page 3

ii
Safety Precautions
WARNING
Do not touch the rollers or moving parts such as the
carriage while cutting or plotting is in progress.
•
Such action may result in injury.
No touching
Be sure to ground the earth terminal.
•
If the plotter is not grounded, the operator could suffer an
electric shock in the event of current leakage.
Ground the Plotter
Keep your hands, hair, etc., away from the rollers or
moving parts such as the carriage even if the plotter is
stopped, as it may suddenly start moving when data is
received.
•
Such action may result in injury.
No touching
Do not disassemble, repair, or remodel the plotter.
•
Such action may cause electric shock or a re hazard due to
current leakage.
•
Contact with the high-voltage parts within the plotter may
cause electric shock.
•
If the plotter requires repairs, contact your sales
representative or nearest Graphtec vendor.
No disassembly
Do not connect the plotter to a non-rated power
supply.
•
Such action may cause electric shock or a re hazard due to
current leakage.
Prohibited
Do not use the plotter in a location where it will be
exposed to water, rain, or snow.
•
Such action may cause electric shock or a re hazard due to
current leakage.
Avoid water
Beware of
electrical shock
If the plotter generates smoke, overheats, emits a
strange odor, or otherwise functions abnormally, do
not continue using it. Turn off the power and unplug
the power cord from the electrical socket.
•
Use of the plotter in such a condition may result in a re
hazard or electric shock.
•
After conrming that smoke is no longer being emitted,
contact your sales representative or nearest Graphtec vendor
for repairs.
•
Never attempt to perform repairs yourself.
Repair work by inexperienced
personnel is extremely dangerous.
Prohibited
Do not allow dust or metal scraps to adhere to the
power plug.
•
Such action may cause electric shock or a re hazard due to
current leakage.
Prohibited
Beware of
electrical shock