GRAPHTEC CE6000 SERIES - Page 4

iii
Safety Precautions
WARNING
CAUTION
Do not use the power cord if it is damaged.
•
Use of a damaged cord may result in electric shock or a re
hazard due to current leakage.
•
Replace the power cord with a new one.
Unplug the power
cord from the socket
Be careful when handling the cutter blade.
•
Touching the blade with your bare hand may cause injury.
•
Do not touch the cutter blade while cutting is in progress.
No touching
Do not use or store the plotter in a location exposed
to direct sunlight or the direct draft of an air
conditioner or heater.
•
Such locations may impair the
performance of the plotter.
Prohibited
Do not use the plotter in an excessively dusty or
humid location.
•
Such locations may impair the performance of the plotter.
Prohibited
Do not place any receptacle containing water or
other uid on top of the plotter.
•
Fluid falling inside the plotter may cause electric shock or a
re hazard due to current leakage.
Avoid water
Beware of
electrical shock
Do not use the plotter in a location subject to
excessive mechanical vibration or electrical noise.
•
Such locations may impair the performance of the plotter.
Prohibited
When disconnecting the power cord or interface
cable, do not pull on the cord/cable.
•
Such action will damage the cord/cable, resulting in a re
hazard or electric shock.
Prohibited
If water or foreign matter enters the plotter,
discontinue use. Turn off the power and unplug the
power cord from the electrical socket.
•
Use of a damaged cord may result in electric shock or a re
hazard due to current leakage.
•
Contact your sales representative or nearest Graphtec vendor
for repairs.
Unplug the power
cord from the socket