GRAPHTEC CE6000 SERIES - Page 41

2-11
5 Position the media and the push rollers to correspond with
the width of the media.
When the CE6000-60
Supplement
The media must always be positioned over
the media sensor.
See "2.4 Aligning the Push Rollers"
P.2-19
about the position of the push rollers.
The push rollers push down on either side of the media. Use
the grit roller position guide to make sure the push rollers are
set on top of the grit rollers.
Push roller
Push roller
Grit roller
Media
Media sensor
Grit roller position guide
When the CE6000-120
Supplement
The media must always be positioned over
the media sensor.
See "2.4 Aligning the Push Rollers"
P.2-19
about the position of the push rollers.
See "2.4 Aligning the Push Rollers"
P.2-19
for information about push roller hold-down
force.
Use the 3 push rollers to push down the sides and center of
the media. Use the grit roller position guide and make sure
the push rollers are on top of the grit rollers.
You can adjust the center push roller's hold-down force.
Grit roller position guide
Push roller
Media sensor
Push roller
Grit roller
Push roller
(The center push roller is not on top of the grit roller.) (The center push roller is near the edge.)
(The push roller is on top of the grit roller.) (The push roller is on top of the grit roller.)