GRAPHTEC CE6000 SERIES - Page 42

2-12
When Feeding Long-axis Media (at exceeds 2 meters)
Position the push rollers at least 15 mm inside the edges of
the media.
Push roller
Media
15 mm 15 mm
When Feeding Long-axis Media (at least 2 meters)
Position the push rollers at least 5 mm inside the edges of
the media.
Push roller
Media
5 mm 5 mm
6 Pull the media taut to make sure that there is no slack in the
conveyance path, and then raise the media set lever to lower
the push rollers.
Media set lever
7 Release the media stopper lock (Pull the sides and slide it
forward.)
Release the
media lock
Media lock