Hioki 3560 - Page 98

86
────────────────────────────────────────────────────
7.4 Message Reference
────────────────────────────────────────────────────
Synta
x
:MEASure:RESistance?
Respons
e
synta
x
(If headers are ON)
:MEASURE:RESISTANCE data1, data2
(If headers are OFF)
data1, data2
HI/IN/LO/FAIL/PASS comparator
results
OFF Comparator is not used.
NG Abnormal measurements
data1 Resistance
Resistance
range
(Ω)
Sampling rate
FAST MEDIUM/SLOW
30 m □□.□□E-3 □□.□□□E-3
300 m □□□.□E-3 □□□.□□E-3
3 □.□□□E+0 □.□□□□E+0
30 □□.□□E+0 □□.□□□E+0
300 □□□.□E+0 □□□.□□E+0
3k □.□□□E+3 □.□□□□E+3
OFF
1.0000E+8 1.0000E+8
NG
1.0000E+9 1.0000E+9
data2
HI/IN/LO/FAIL/PASS comparator
results
OFF Comparator is not used.
NG Abnormal measurements
Exampl
e
(If headers are ON)
Transmission
:MEAS:RES?
Response
:MEASURE:RESISTANCE 20.123E‑3,IN
(If headers are OFF)
Transmission
:MEAS:RES?
Response
20.123E‑3,IN
F
unctio
n
･ This command returns the current
measured resistance in NR3
numeric data format (data1), and
the comparator result in
HI/IN/LO/OFF/NG character data
format (data2)or
FAIL/PASS/OFF/NG character data
format (data2).
･ HI/IN/LO is returned in voltage
measurement mode, while
FAIL/PASS is returned in
resistance and voltage
measurement mode.
:MEASure:RESistance?
■ Queries for the current measured resistance and comparator result.