Hioki 7075 - Page 117

107
────────────────────────────────────────────────────
8.3.4 Specific Commands for Floppy Disk
────────────────────────────────────────────────────
Syntax
:FILE:LOAD "<file>"
"<file>" Name of status setting file
Example
Transmission
:FILE:LOAD 'OUTSET.OUT'
Reads the OUTSET.OUT file.
Syntax
:FILE:DELete "<file>"
"<file>"= File name
Example
Transmission
:FILE:DEL 'OUTSET.OUT'
Deletes the OUTSET.OUT file.
Function
Loads the status settings contained in
the file with the specified name from
the floppy disk.
Notes
The file name must be surrounded by
single (' ') or double (" ") quotes.
Long file names cannot be used. File
names are case sensitive.
A file name cannot include a
directory. Loading can be done only
from the current directory.
When an arbitrary waveform file is
specified for loading the status of a
channel, the arbitrary waveform that
has been entered is deleted.
When the load finishes normally,
EOFO in Event Status Register 0 is
set.
Errors
(Command error)
When a file name is not surrounded by
single (' ') or double
(" ") quotes
(Execution error)
While RUN is active
Function
Deletes the specified file or directory
from the floppy disk.
Notes
The file name must be surrounded by
single (' ') or double (" ") quotes.
Long file names cannot be used. File
names are case sensitive.
A file name cannot include a
directory. Deleting can be done only
from the current directory.
When the load finishes normally,
EOFO in Event Status Register 0 is
set.
Errors
(Command error)
When a waveform name is not
surrounded by single (' ') or double
(" ") quotes
(Execution error)
When deletion fails due to write
protection
:FILE:LOAD
Loads the status settings contained in the file.
:FILE:DELete
Deletes files.