Hioki 7075 - Installation; Loading the Program; Operation

128
────────────────────────────────────────────────────
9.3 Installation
────────────────────────────────────────────────────
CAUTION
If the power to the computer or the computer power switch is turned off
while setup.exe is running, hard disk contents may be destroyed.
NOTE
9.3 Installation
9.4 Loading the Program
9.5 Operation
1. Confirm that the operating environment conditions of "11.2.1 General
Specifications" are satisfied, then insert 7990 CD-R into the CD drive.
2. Double click \English\setup.exe on the disk to run it.
3. Follow the on-screen instructions to install the 7990
WAVEFORM CREATION
SOFTWARE
.
4. Confirm that the software installed correctly.
If installed in the Start menu, click the Start button, select Hioki, and then
Waveform Software.
If not installed in the Start menu, execute wavesoft.exe in the folder where
the 7990
WAVEFORM CREATION SOFTWARE
is installed.
Refer to the on-line help for operating procedures with the program running.
If problems occur with data transfer
Check the following items if problems occur with data transfer:
Confirm that the settings in the File - Interface Settings menu of the 7990
WAVEFORM CREATION SOFTWARE
match the RS-232C settings in the
7075 ("5.3.2 Setting the RS-232C Interface").
Confirm that the connections with the PC are correct.
Confirm that the same waveform name is not already present on the 7075. If
it is, the waveform data cannot be sent. Change the name of the waveform
in the File - Properties menu.
Data cannot be sent when the 7075 is in the following states:
When a waveform with the same name already exists on the 7075.
When there are already 8 waveforms stored in the 7075.
When using Save As, if the arbitrary waveform is given the same name as a
waveform already specified for arbitrary waveform output on the 7075.
When using Save As, if the arbitrary waveform is given the same name as a
waveform already specified for sweep arbitrary waveform output on the
7075.