Hioki 7075 - Specific Commands for Floppy Disk

106
────────────────────────────────────────────────────
8.3.4 Specific Commands for Floppy Disk
────────────────────────────────────────────────────
Syntax
:FILE:SAVE "<file>"
"<file>" Name of status settings file
Example
Transmission
:FILE:SAVE 'OUTSET.OUT'
Creates and saves output status
settings in the OUTSET.OUT setting
file.
Function
Current settings are written to the
floppy disk as the status settings file
with the specified file name.
Notes
The file name must be surrounded by
single (' ') or double (" ") quotes.
Long file names cannot be used. File
names are case sensitive.
A file name cannot include a
directory. Loading can be done only
from the current directory.
When the load finishes normally,
EOFO in Event Status Register 0 is
set.
The file name may consist of capital
letters and ! # % $ - ^ and _
characters. The name must conform to
the "8.3" MS-DOS file naming format.
Lower-case letters are converted to
capitals.
Example
OUTSET.OUT, 123FILE, F-01.FIL
Errors
(Command error)
When a waveform name is not
surrounded by single (' ') or double
(" ") quotes
(Execution error)
Writing is inhibited by the write-
protect tab on the media.
When already existing file is specified.
8.3.4 Specific Commands for Floppy Disk
:FILE:SAVE
Writes to the floppy disk as the status settings file